Eris E7 XT
- 6.5-inch woven composite low-frequency transducer
- 1.25-inch (31.75 mm), ultra-low-mass, silk-dome, high-frequency transducer
- 100˚(H) x 60˚(V) EBM waveguide for wide sweet spot
- Front-firing acoustic port for superior bass-frequency reproduction
- Optimized, resonance-suppressing internal bracing
- 104 dB maximum continuous SPL
AED899
Guaranteed Safe Checkout
Features & Compatibility
The best in UAE
It’s easy to feed audio to your Eris E7 XT studio monitors from an audio interface, mixer, monitor controller, or almost any other line-level source. Eris E7 XT monitors provide balanced XLR, balanced ¼-inch TRS, and unbalanced RCA line-level inputs. You’ll have no problem hooking your Eris speakers up to virtually anything.
Technical Specifications
Inputs |
|
|---|---|
| 1- Balanced XLR | |
| 1- Balanced ¼” TRS | |
| 1- Unbalanced RCA |
Performance |
|
|---|---|
| Frequency Response | 42 Hz – 20 kHz |
| Crossover Frequency | 2.5 kHz |
| LF Amplifier Power | 75W |
| HF Amplifier Power | 65W |
| Peak SPL (@ 1 meter) | 104 dB |
| LF Driver | 6.5” reinforced woofer |
| HF Driver | 1.25” silk dome tweeter |
| Input Impedance | 10 kΩ |
| Dispersion | 100 degrees horizontal by 60 degrees vertical |
User Controls |
|
|---|---|
| Volume Range | A-type taper |
| MF Control | -6, 0, +6 dB |
| HF Control | -6, 0, +6 dB |
| Low Cut | Flat, 80 Hz, 100 Hz |
| Acoustic Space | Flat, -2 dB, -4 dB |
Protection |
|
|---|---|
| RF interference | |
| Output-current limiting | |
| Over-temperature | |
| Turn-on/off transient | |
| Subsonic filter | |
| External mains fuse |
Power |
|
|---|---|
| 100-120V ~50/60 Hz or 220-240V ~50/60 Hz |
Cabinet |
|
|---|---|
| Vinyl-laminated, medium-density fiberboard |
Physical |
|
|---|---|
| Width | 9.4” (240 mm) |
| Depth | 9.5” (242 mm) |
| Height | 14.4” (365 mm) |
| Weight | 18.5 lbs (8.4 kg) |
Additional information
| Brand |
|---|
Customer Reviews
Related Products
Temblor T10
- Input gain control (-30 dB to +6 dB, continuously variable)
- Continuously variable lowpass filter (50 Hz to 130 Hz)
- Built-in crossover
- Switchable highpass filter removes frequency content below 80 Hz from the full-range signal sent from the Temblor outputs to the main monitors
- Momentary footswitch (included) bypasses the subwoofer, highpass filter, and Sub Out
- Polarity invert
- Ground-lift switch
Reviews
There are no reviews yet.